Connecting to Refrigerator
Style 1
1.Unplug refrigerator or disconnect power.
2.Attach the copper tube to the valve inlet using a compression nut and sleeve as shown. Tighten the compression nut. Do not overtighten.
3.Use the tube clamp on the back of the refrigerator to secure the tubing to the refrigerator as shown. This will help prevent damage to the tubing when the refrigerator is pushed back against the wall.
4.Turn shutoff valve ON.
5.Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak.
1. | Tube clamp | 3. | Compression nut |
2. | Copper tubing | 4. | Valve inlet |
6.The ice maker is equipped with a
7.Plug in refrigerator or reconnect power.
8.Flush the water system. See the “Water System Preparation” section.
NOTE: Allow 24 hours to produce the first batch of ice. Allow 3 days to completely fill ice container.
Style 2
1.Unplug refrigerator or disconnect power.
2.Remove the shipping tape from the gray, coiled water tubing on the rear of the refrigerator.
3.Thread the provided nut onto the coupling on the end of the copper tubing. Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten.
| 1 | 2 | 3 | 4 | 5 | 6 |
1. | Line to refrigerator | 4. | Coupling (purchased) | |||
2. | Nut (provided) |
| 5. | Ferrule (purchased) | ||
3. | Bulb |
|
| 6. | Nut (purchased) | |
4.Turn shutoff valve ON.
5.Check for leaks. Tighten any nuts or connections (including connections at the valve) that leak.
6.The ice maker is equipped with a
7.Plug in refrigerator or reconnect power.
8.Flush the water system. See the “Water System Preparation” section.
NOTE: Allow 24 hours to produce the first batch of ice. Allow 3 days to completely fill ice container.
Style 3
1.Unplug refrigerator or disconnect power.
2.Remove the shipping tape from the gray, coiled water tubing on the rear of the refrigerator.
3.Thread the provided nut onto the water valve as shown.
1 |
2 |
1.Bulb
2.Nut (provided)
NOTE: Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten.
4.Turn shutoff valve ON.
5.Check for leaks. Tighten any nuts or connections (including connections at the valve) that leak.
6.The ice maker is equipped with a
7.Plug in refrigerator or reconnect power.
8.Flush the water system. See the “Water System Preparation” section.
NOTE: Allow 24 hours to produce the first batch of ice. Allow 3 days to completely fill ice container.
Water System Preparation
(on some models)
Please read before using the water system.
Immediately after installation, follow the steps below to make sure that the water system is properly cleaned.
1.Open the freezer door and turn off the ice maker by lifting up the wire shutoff arm as shown.
MAX
NORMAL
NOTES:
■If your model has a base grille filter system, make sure the base grille filter is properly installed and the cap is in the horizontal position.
■Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.
9
