control console
console, allowing panel(s) to rest on
bottom of door.
Push in along
6 n Snap one end of retainer into channel as shown. Push inward while sliding thumb along full length of retainer.
To change access colour panel
(For models so equipped)
Injury Hazard
Wear gloves and handle panels carefully.
Cut metal edges are sharp and may cause serious injury.
1 n Push up with thumbs on each end of access panel top trim to unsnap trim.
Remove top trim and set it aside.
2 n Carefully slide colour access panel upwards and remove. Do Not remove spacer.
3 n With desired colour facing out, bow access
panel and
access panel frame. Slide panel down into groove along bottom of access panel frame.
4 H Line up edges of top trim with sides of access panel frame.
Tilt back of trim down and slide into place. Snap front of trim down to cover top edge of access panel.
Parts that must be custom made
Maxlmum custom door panel weight Is 4 pound (1.8 kg).
Dishwasher door panel and access panel (if model is so equipped)
can be customized to match wood cabinets. A standard, l/4”* wood panel can be used as is for customizing the door and access
panels. It is recommended that a
cabinetmaker cut the customized panel pieces because of the precise dimensions needed.
l Cut wood panels so that wood grain matches direction of grain in cabinets.
l File or sand edges of wood panels.
l Dishwasher is subject to some humidity. Apply
* 7132” (0.56 cm) actual thickness.
Custom
door and access panels
The custom door panel must not weigh more than 4 pounds
(1.8 kg).
Cut door panel accurately for a snug fit between door side frames.
Note: Custom door panel fits between, Not inside frame.
7/32” (0.56 cm) thickness
Page 10
