Custom panel dimensions
Note: This panel is narrower than access panel.
File or sand edges of wood panel to avoid slivers.
door panel
side view
top edge 7132” (0.56 cm)
edge
door panel
front view
L23” | (58.4 cm)& |
access panel
-
All edges routed to 7132” (0.56 cm) thickness.
Note: This panel is wider than the door panel.
Routing custom panels
clear access when door is
7132”
topview (0.56 cm) thick
(O.&l cm) min.
Custom door panel more than 7/X2” (0.56 cm) thick: Route top and bottom to 7/32” (0.56 cm) thickness.
Custom access panel more than 7/32” (0.56 cm) thick: Route all four sides to 7/32” (0.56 cm) thickness.
Custom panels less than 7/X!” (0.56 cm) thick: Install spacers behind panels.
wood panels in door and access panel
1 n Cut wood door and access panels using specified dimensions, Make sure wood grain direction matches cabinet wood grain.
2 n File or sand edges of wood panels to avoid slivers.
Dlshwasher Is subject to some humldlty. Cover both sides and ed es of wood panels wlth
Injury Hazard
Wear gloves and handle panels carefully.
Cut metal edges are sharp and may cause serious injury.
3 n Insert finger under one end of retainer and bull towards iou in a peeling action. Set retainer aside.
4 n Lift door panel(s) at outer edges. Use one po~~~obpw
panel(s). Remove panel(s) and spacer. Save panel(s) and
spacer for future use.
Page 11