ins be sid
panel fits betwe&
not inside, door frame
5 n Insert top of wood door
panel between sides of door frame about 3” (7.5 cm) below console. Rotate wood door panel down against dishwasher door. Slide top edge of wood door panel under bottom edge of console. Press lower portion of wood door panel in place between sides of door frame, allowing wood door panel to rest on channel at bottom
of door.
Push in
along length of retainer.
6 n Snap one end of retainer into channel as shown. Push inward while sliding thumb along full length of retainer.
Part No. 3369689 01996
7 n Check door for proper
0Der .ation. Door should close easilv without slamming and open with ’ its own weight. If necessary, close door and adjust both door springs by moving spring ends to different holes in base.
8 n Push up with thumbs on each end of access
unsnap trim. Remove top trim and set it aside.
9.
Carefully slide colour access panel and spacer upwards and remove,
Save colour access panel and spacer for future use.
10 n Insert wood access panel into access panel frame. Slide panel down into groove along bottom of access panel frame. It may be necessary to remove the two screws securing top of access panel to dishwasher frame and tilt access panel forward to install some wood panels,
11 n Line up edges of top trim with sides of access panel frame
Tiltbackof$m w
down and slide into place. Snap front of trim down to cover top edge of wood access panel.
Benton Harbor, Michigan 49022
If the dishwasher is not operating properly.. .
Check these points:
l Is the door closed tightly and
latched securely? -
l Has the cvcle been set correctly to start the dishwasher?
l Is the water supply turned on? l Has the electrical power been
connected?
l Has the circuit breaker been tripped or the house fuse blown?
l Has electrical power been interrupted?
Note: If the motor is stopped because of overload, it will
automatically reset itself within a few minutes. If after checking these points the dishwasher still does not run or complete a cycle, call for service.
If you need
assistance...
Call your dealer or authorized repair service.
When you call, you will need the dishwasher model number and serial number. Both numbers can be found on the model/serial rating plate behind the dishwasher door on the front frame,
Printed in U.S.A.
