Gas Supply Requirements

WARNING

Explosion Hazard

Use a new CSA International approved gas supply line. Install a shut-off valve.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (360 mm) water column.

Examples of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service personnel.

Failure to do so can result in death, explosion, or fire.

IMPORTANT: Observe all governing codes and ordinances.

This installation must conform with all local codes and ordinances. In the absence of local codes, installation must conform with American National Standard, National Fuel Gas Code ANSI Z223.1/NFPA 54.

A copy of the above code standards can be obtained from:

National Fire Protection Association

One Batterymarch Park, Quincy, MA 02269

The design of this dryer has been certified by CSA International for use at altitudes up to 10,000 feet (3048 m) above sea level at the B.T.U. rating indicated on the model/serial plate. Burner input adjustments are not required when the dryer is operated up to this elevation.

When installed above 10,000 feet (3048 m), a four percent (4%) reduction of the burner B.T.U. rating shown on the model/serial plate is required for each 1,000 foot (305 m) increase in elevation. For assistance when converting to other gas types and/or installing above 10,000 feet (3048 m) elevation, contact your local service company.

Type of Gas

This dryer is equipped for use with natural gas. It is design- certified by CSA International for L.P. (propane and butane) gases with appropriate conversion. No attempt shall be made to convert the dryer from the gas specified on the serial/rating plate for use with a different gas without consulting the serving gas supplier. Conversion must be done by a qualified service technician. Gas conversion kit part numbers are listed on the gas valve burner base.

Gas Supply Line

Recommended method

Provide a gas supply line of 1/2" rigid (IPS) pipe to the dryer location. Pipe joint compounds that resist the action of LP gas must be used. Do not use TEFLON®† tape. With LP gas, piping or tubing size can be 1/2" minimum. Usually, LP gas suppliers determine the size and materials used in the system.

Alternate method

The gas supply may also be connected using 3/8" approved copper or aluminum tubing. If the total length of the supply line is more than 20 feet (6.1 m), larger tubing will be required. If using natural gas, do not use copper tubing. Pipe joint compounds that resist the action of LP gas must be used.

Flexible metal appliance connector:

It is recommended that a new flexible stainless steel gas line, design-certified by CSA International, be used for connecting the dryer to the gas supply line. (The gas pipe which extends through the lower rear of the dryer is provided with 3/8" male pipe thread.)

Do not kink or damage the flexible stainless steel gas line when moving the dryer.

Rigid pipe connection:

The rigid pipe connection requires a combination of pipe fittings to obtain an in-line connection to the dryer.

Must include a shutoff valve:

The supply line must be equipped with a manual shutoff valve installed within 6 ft. (1.8 m) of dryer in accordance with National Fuel Gas Code, ANSI Z223.1. This valve should be located in the same room as the dryer. It should be in a location that allows ease of opening and closing. Do not block access to shutoff valve. The valve is for turning on or shutting off gas to the dryer.

B

A

C

A. Gas supply line

B. Shutoff valve “open” position

C. To dryer

Installed in a confined area:

If the dryer is installed in a confined area such as a bathroom or closet, provision must be made for enough air for combustion and ventilation. Check governing codes and ordinances or refer to the “Recessed Area and Closet Installation Instructions” in the “Location Requirements” section

†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.

7

Page 6 Page 8
Page 7
Image 7
Whirlpool 8577213C installation instructions Gas Supply Requirements, Type of Gas, Gas Supply Line
Page 6 Page 8

8577213C specifications

The Whirlpool 8577213C is a versatile and innovative appliance that stands out in the crowded market of kitchen solutions. As a part of Whirlpool's extensive range, this model is designed to meet the demands of modern cooking while offering user-friendly features.

One of the most notable characteristics of the Whirlpool 8577213C is its efficient design. This appliance is crafted with high-quality materials, ensuring durability and longevity in daily use. Its sleek and modern aesthetic not only enhances the kitchen’s appearance but also makes cleaning a hassle-free experience. The smooth surface helps to resist stains and marks, preserving its visual appeal over time.

Functionality is at the core of the Whirlpool 8577213C. It comes equipped with an array of cooking technologies that allow users to prepare meals with precision and ease. This model features advanced cooking settings, including multiple temperature ranges and preprogrammed options that cater to various cooking needs. Whether you're roasting, baking, or broiling, this appliance delivers consistent results every time.

Another standout feature is its intuitive control panel, which simplifies the cooking process. The user interface is designed to be straightforward, making it accessible for cooks of all skill levels. With clearly labeled buttons and easy-to-read displays, users can quickly navigate through options and set their desired cooking modes.

The Whirlpool 8577213C also emphasizes energy efficiency, adhering to ecological standards while delivering powerful performance. It is engineered to minimize energy consumption, making it an environmentally friendly choice without compromising cooking quality. This model not only saves on utility bills but also aligns with the increasing consumer demand for sustainable appliances.

In addition to its technical features, safety is prioritized in the Whirlpool 8577213C design. It includes safety lock functions and automatic shut-off settings. These features provide peace of mind while cooking, knowing that the appliance will operate safely even during busy kitchen routines.

In summary, the Whirlpool 8577213C represents the perfect blend of style, efficiency, and advanced technology. With its durable construction, user-friendly interface, energy-saving capabilities, and safety features, it is an essential tool for any modern kitchen. Whether you're a novice cook or a seasoned chef, this appliance enhances the culinary experience, streamlining the process and maximizing creativity in the kitchen.
Top Page Image Contents