air blower and light. Refer to the Control Panel illustra-
tion for an explanation of the various switch functions.
SYSTEM
The SYSTEM switch controls the following four func-
tions in the continuous sequence indicated:
1. OFF
2. JETS
3. HTR/FLTR
4. FILTER
(The next selection is OFF again.)
Use the JETS function as a reference to indicate your
location in the function sequence, since that function is
the most obvious when operating.
For best performance and increased equipment life,
pause a second or two between push-button selections.
Not pausing may cause the switch to malfunction.
ACCESSORY
continuous sequence indicated:
1. OFF
2. AIR
3. AIR/LIGHT
4. LIGHT
Temp. Control
Turn on the heater by selecting the HTR/FLTR mode
with the SYSTEM switch.
With this selection, you can verify that the spa’s
heater is operating by viewing the indicator light on the
spa control panel.
(The next selection is OFF again.)
The ACCESSORY switch controls these functions in the
8
OPERATION

S

OFF
(Time clock controls
filter pump. Heater will turn
on with filter
pump if thermostat is set.)
JETS
(Maximum whirlpool
action. Heater will
maintain temperature set
by thermostat if converted
to 230 VAC.)
HTR/FILTER
(Filter pump and heater
will turn on as necessary
to maintain water
temperature setting.)
TEMP.
CONTROL
KNOB
ACCESSORY SWITCH
(Controls Air Blower and
light functions.)
SYSTEM SWITCH
(Controls Jets,
Heater/Filter and Fliter
Only functions.)
FILTER
(Filter pump will run
continuously; heater will
turn on as necessary to
maintain water
temperature setting.)
HEATER
INDICATOR
LIGHT
BATTERY
TEMPERATURE
READOUT