B. Spa is up to temperature set
PROBABLE CAUSE REMEDYPROBLEM
A. Timer is functioning.13. Accessory Switch and system
switch in off position, but motorand heater still operating.
A. Normal function. Turn timer
to an off position, or reset
tabs in off position.
A. System and/or accessory switch
is not in off position. A. Turn both system switch and
accessory switch to off position.
B. Turn thermostat down. If
on thermostat. thermostat is already at minimum
setting, and spa is at or above
that temperature, timer will
not operate.
*Note: The skills and tools necessary for the safe repair of this spa require the services
of qualified service personnel. Contact your Jacuzzi Whirlpool Bath Authorized
Service Agent or Dealer.
1810. Motor will not start.
(Continued) I. Subnormal voltage.
J. Locked shaft or impeller.
K. Motor windings burned out.
L. Defective starting switch inside
motor.
I. Call an electrician or your power
company.
J. *
K. *
L. *
11. Motor stops. A. Motor overload condition.
B. High temperature safety switch
tripped.
C. Selector switch failure.
D. Relay failure.
E. Inadequate supply wiring.
A. Let cool for one hour. Motor
overload will reset if problem
persists, see *Note.
B. Reset button on heater after
water has cooled; see *Note if
switch continues to trip.
C. *
D. *
E. Consult electrician to correct
wiring to unit.
12. Air Blower does not operate. A. Power off.
B. ACCESSORY switch in OFF.
C. House circuit breaker tripped, no
power to system.
D. GFCI tripped.
E. Faulty motor.
A. Turn on power at service panel.
B. Select other function.
C. Reset circuit breaker.
D. Reset GFCI.
E. *
14. Timer will not activate spa.
TROUBLESHOOTING GUIDE