10
HIGH VOLUME FULLY
ADJUSTABLE WHIRLPOOL JET
SILENT AIR CONTROLS
OPERATION
MAXIMUM AIR
OUTPUT (COUNTER
CLOCKWISE
ROTATION)
MAXIMUM AIR
OUTPUT
(CLOCKWISE
ROTATION)
WHIRLPOOL
WATER JETS
ONLY
Normal Operation

Whirlpool System

You can enjoy the Razza Plus spa with or without
activating the whirlpool. Either way, bathing in your spa
can be pleasurable, as well as therapeutic.
For an invigorating spa experience, you can take
advantage of the built-in whirlpool system. To do this,
push the SYSTEM switch button to select the JETS
mode. Sit or recline in the spa so you are comfortable.
The fully adjustable whirlpool jets can be adjusted to
control the force of the water coming into the spa. For
stimulating action, increase the force of the flow by
rotating the jet handle to the left. For a more relaxing
effect, rotate the handle to the right (clockwise). The
directionally adjustable whirlpool jets can be directed
toward any location on the body, particularly toward any
area that feels tense or stiff. The warmth of the water and
the stimulating water flow from the jet will pleasantly
increase circulation.
Or, for the total whirlpool effect and all-over feeling of
well-being, you can adjust all jets so they point in a
clockwise or counter-clockwise direction to circulate the
air and water mixture in a circular motion all about the
spa.
Finally, after a busy, stressful day, you can look
forward to soaking in your spa in still water with no
turbulence-only the gentle warmth of the soothing and
relaxing water.

Silent Air Induction

The intensity of the whirlpool action is determined by
how much air is inducted into the water. You have
control of this by adjusting the air induction control knobs
located on both control panels. For maximum air induc-
tion, rotate each control knob fully counter clockwise to
the largest circle. For fewer air bubbles, decrease the
amount of air induction by rotating the control knob
clockwise. When the knobs are turned to the smallest
circles, only water is being circulated.

Air Blower

The Razza Plus features a built-in air blower and
factory drilled air holes in the seats of the spa to add to
your enjoyment. The blower sends air to a channel
located under the spa's seats; this air is distributed
through the air holes, forming tiny bubbles which travel
upward until they reach the surface and burst. The
exciting visual effect of the bursting bubbles contributes
to the overall hydromassage experience.
Activate the blower by pushing the ACCESSORY
switch. (Note that the filter pump will also come on
at this time.)

Filtration

When you are ready to leave the spa, push the
SYSTEM switch button to turn off the whirlpool. Then
select the HTR/FLTR mode. Adjust the HEATER knob
to the temperature at which you wish the water main-
tained. In this way, the water will be filtered when the
heater goes on to maintain the temperature. Whenever
the water temperature reaches the desired temperature,
the pump will turn off.
For continuous filtration, select FILTER on the SYS-
TEM switch. In this mode, the filter pump will run until it
is manually deactivated while maintaining the water
temperature selected by the HEATER knob. Set the
HEATER knob to its lowest setting unless you wish the
higher temperature to be maintained. Running the filter
pump for at least two hours per day is sufficient.
Another way to be sure the water will be filtered is to
turn the SYSTEM off and set the built-in timer in the
System Control Module to turn the system on at a certain
time to filter the water. Be sure there is sufficient water in
the spa (filled to the water line indicator mark on the
skimmer/filter frame) when the timer is set, or the spa’s
motor/pump could be damaged. (See page 7 for instruc-
tions on setting the timer.)