Whirlpool 960 Series warranty PROBLEM Spotting and filming, Cycle takes extremely long time, Cause

Models: 960 Series

1 27
Download 27 pages 3.14 Kb
Page 21
Image 21
PROBLEM

PROBLEM

Spotting and filming

(continued)

Cycle takes extremely long time

Dishes do not dry completely

Silica film or etching

(silica film is a white iridescent deposit; etching is a cloudy film)

Black or gray marks on dishes

Whlte spots on cookware with non-stick finish

CAUSE

Use of incorrect detergents

Incorrect amount of detergent

Use of ineffective detergents

lnsuff icient fill due to low water pressure

Water temperature is too low

Dishwasher is not installed properly

Dishes do not drain properly

Plastics

Water chemical reaction with certain types of glassware - usually caused by some combination of soft or softened water, alkaline washing solutions, insufficient rinsing, overloading the dishwasher, and heat of drying.

Aluminum items touching dishes

Seasoning removed by dishwasher detergents

SOLUTION

Use recommended dishwasher detergents only.

Follow recommendations on page 10 for amount. Heavy soil and/or hard water generally require extra detergent.

Use fresh detergent. Store detergent tightly closed in a cool, dry place. Discard lumpy detergent.

Home water pressure should be 20 to 120 psi for proper dishwasher fill. A booster pump on the water supply may be neces- sary if pressure is too low.

If needed, turn home water heater up to ensure water entering dishwasher is 120°F (49°C) minimum. See “Tocheck water temperature” on page 19.

Undercounter dishwashers require ad- equate enclosure for proper operation. See Installation Instructions for complete information.

Dishes must have proper water drainage. Do not overload. Follow instructions fo; loading dishwasher on pages 6-9. Use a liquid rinse agent to speed draining.

Some plastics, due to material, may need to be towel dried.

It may not be possible to prevent problem, except by hand washing. To slow this process, use a minimum amount of deter- gent but not less than one tablespoon per load. Use a liquid rinse agent and underload the dishwasher to allow thor- ough rinsing. Silica film and etching are permanent and cannot be removed. Use the AIR DRY option.

Load aluminum items so that they will not rub against dishes during washing. Do not wash throwaway aluminum items in the dishwasher because they may break down and cause marking. Remove aluminum markings by using a mild abrasive cleanser.

Reseason cookware after dishwasher washing.

continued on next page

21

Page 21
Image 21
Whirlpool 960 Series warranty PROBLEM Spotting and filming, Cycle takes extremely long time, Silica film or etching, Cause