¹⁄₄"
(0.6 cm)
■230 volt (207 min. - 253 max.)
■230/208 volt (197.6 min. - 253 max.)
■
■
■Use on single outlet circuit only.
■230 volt (207 min. - 253 max.)
■230/208 volt (197.6 min. - 253 max.)
■
■
■Use on single outlet circuit only.
Recommended ground method
For your personal safety, this air conditioner must be grounded. This air conditioner is equipped with a power supply cord having a grounded 3 prong plug. To minimize possible shock hazard, the cord must be plugged into a mating, grounded 3 prong outlet, grounded in accordance with all local codes and ordinances. If a mating outlet is not available, it is the customer's responsibility to have a properly grounded 3 prong outlet installed by a qualified electrical installer.
It is the customer's responsibility:
■To contact a qualified electrical installer.
■To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA 70 - latest edition, and all local codes and ordinances.
Copies of the standards listed may be obtained from:
National Fire Protection Association
One Batterymarch Park
Quincy, Massachusetts 02269
INSTALLATION INSTRUCTIONS
Unpacking
WARNING
Excessive Weight Hazard
Use two or more people to move and install air conditioner.
Failure to do so can result in back or other injury.
Remove packaging materials
■Remove and properly dispose of packaging materials. Remove tape and glue residue from surfaces before turning on the air conditioner. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.
■Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your air conditioner.
■Handle air conditioner with care.
1.Remove air conditioner from carton and place on cardboard.
2.Remove shipping screw from side wall of cabinet.
A
A. Shipping screw
3.Pull control knobs off (on some models).
4.Remove front panel from air conditioner and set aside.
5.Remove ground screw and ground wire from front of air conditioner base. Save ground screw.
A
+
+ B
A. Green ground wire
B. Ground screw
6.Pull on handle to slide air conditioner out of cabinet. Place air conditioner on cardboard.
A
A. Handle
NOTE: Do not lift, push, pull or remove any expanded polystyrene (foam) from inside the air conditioner. It is not packing material.
5
