Whirlpool ACS052XH1 warranty Failure to do so can result in back or, Other injury

I N S T A L L I N G Y O U R A I R C O N D I T I O N E R

10. Slide the air conditioner onto the support	WARNING
platform. Be sure the unit side channel
butts against the vertical edge of the
	Excessive Weight Hazard
window frame. Watch out for the sharp
	Use two or more people to move and
metal fins on the front and rear coils.
NOTE: If unit side channel does not fit	install air conditioner.
	Failure to do so can result in back or
securely, remove air conditioner and
readjust leveling bolt.	other injury.

11.Using the existing clearance holes in the air conditioner’s bottom bar as guides,

drill two 1⁄8" holes through the window	Drilled holes
channel frame. Install two self-threading
screws through the clearance holes and
into these holes. Tighten the screws
securely. The air conditioner should be
firmly anchored to the window channel		Bottom
frame. Be sure your air conditioner does
		bar
not fall out during installation.
		Screw
12. Slide the inside window sash closed.
Make sure the vertical edge of the inside
window sash is pressed firmly against the	Support platform	Window channel frame
side of the unit cabinet. Cut remaining

adhesive back foam seal equal to the width of the window opening. Remove the backing and apply to the top inside edge of the window frame.

13.Install the speed clips on the top and bottom inside edges of the window to provide locking.

14.Insert the appropriate plastic foam seal between the inside window sash and the outside window.

15.Place the top retainer on the top edge

of the filler panel. Then place the bottom edge of the filler panel into the groove of the bottom retainer which is mounted on the air conditioner. The filler panel may be trimmed with a knife or scissors to fit the window height.

16.Slide the sliders upward making sure the filler panel aligns in the sliders.

17.With the sliders up against the top re- tainer, drill 1⁄8" hole through the window frame using the existing clearance hole in the slider as a guide. Install the self- threading screw in the hole and tighten securely. Repeat for the other slider.

18.Check all seals and plug all air leaks around the air conditioner with a suitable weather-proof sealing compound.

Channel

Speed clip

Foam seal

11