Starting the air conditioner using the control panel
1.Select an operating mode by pressing the ON/MODE A (up) or V (down) pads until the indicator light next to the desired mods is lit.
The compressor and fan run until the temperature setting is satis-
COOLS The compressor and fan run until the temperature setting is satisfied. Then both cycle on and off to keep the temperature constant.
gi
and pulls excess moisture out of
NOTE: The COOLS setting saves energy by cycling the fan on and off.
2.Select a fan speed by pressing the FAN SPEED pad. The unit always starts in AUTO fan speed. Each press of the pad advances the fan speed through the speed cycle.
HIGH
NOTE: Once the FAN SPEED pad is pressed, the only way to return to AUTO fan speed from the Control Panel is to turn the unit off, wait 3 minutes, and turn the unit on again.
In AUTO fan speed, the unit automatically selects a temperature setting according to the room temperature. If room temperature is 78’ or above, the unit cools to 75’. If room temperature is 77” or below, the unti cools to 3” below room temperature.
3.Set the desired temperature by pressing the TEMP A (up) or V (down) pads until the indicator light(s) next to the desired temperature is lit. For continuous cooling when using the COOL or COOL* modes, set the temperature to 65’.
When 2 indicator lights are lit, the selected temperature is l/2way between the two temperatures. For example, if the indicator lights for 65” and 70” are lit, the selected temperature is 67.5”.
The OFF pad
The OFF pad turns the air conditioner off. You can turn the air conditioner on again by following steps
8
