Whirlpool ACXO82XZO warranty Setting the clock on the remote control

Setting the clock on the remote control

It is not necessary to set the clock on the remote control to operate the air conditioner. However, it is important to set the correct time of day if you want to use the AUTO START and AUTO STOP functions. This clock activates the AUTO START and AUTO STOP functions, and it resets the air conditioner’s internal clock every time a new transmission is made.

To ret the clock

1. Press the CLOCK SET pad.

2.Press the TIME A (up) or V (down) pads until the correct time of day appears in the display. Be sure the time is set correctly for AM or PM.

For a 24-hour time display, press the TIME V pad. While holding in the TIME V pad, press the TIME A pad. “24H”will show next to the set time.

NOTE: For faster time movement, hold in the A or V pad.

3.Press the CLOCK SET pad again to save your time of day setting. You should hear a confirmation beep from the air conditioner.

This example shows a set time of day of 12:OOPM (noon).

NOTE: The clock runs continuously-whether the remote control is on or off. After removing or replacing the batteries, the clock will have to be reset.