installation - 70CM
Method 1: Without housing unit(between 2 base units)
Before installing the appliance, check the internal dimensions as shown.
The space for the appliance must be clear of obstruction. You may have to cut into or remove any rear cross members to obtain the 550mm minimum depth.
The Fixing Kit
Should you need a replacement fixing kit please call the customer care helpline and order part number: 01 28287 00.
In the fixing kit you will find 2 side trims (687mm long) and 4 runners (420mm long). The fixing screws are in a polythene bag in the oven.
1.Take the 6 No 8 x 12mm (silver) self tapping screws from the polythene bag, and use them to fit one runner to each side of the appliance.
2.Make sure they are the right way up as shown.
3.Take one of the side trims, hold it against the side of the base unit, and mark off 687mm from the top edge of the base unit, to the top edge of the runner.
Note: This ensures a 5 - 8mm clearance from the underside of the worktop to the top of the appliance.
4.Measure 50mm from the front edge of the base units, to mark the front edge of the runners.
5.Take 6 of the No 8 x 12mm (Black)
chipboard screws and screw the runners into opposition the right way up as shown.
6.Fit the side trims to be flush to the top and front edges of the base units, using the remaining 6 No 8 x 12mm (Black) chipboard screws.
