Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so can result in death
or electrical shock.
Before you start.. .Proper installation is your responsibility.
Make sure you have everything
necessary for correct installation. It
is the responsibility of the customer to
contact a qualified installer to assure
that the plumbing and electrical
installations are adequate and meet
all national and local codes and
ordinances.
Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
Proper electrical, drain and water supply lines must be
available or must be installed as specified within shaded
area. See Electrical, Water and Drain requirements.
Plumbing and wiring should not cross in front of motor
or dishwasher legs.
Corner location 2” (5 cm)
minimum door to cabinet
or wall
IMPORTANT:
Observe all governing
codes and ordinances.
Electrical ground is required.
See Electrical requirements.
Do Not install dishwasher over
carpeted flooring.
Do Not pinch power supply cord or kink
power supply cable between dishwasher
and cabinet.
Check location where dishwasher will
be installed. The location should provide:
. Easy access to water, electricity and
Openfttg width
drainage lines.
Figure 1
l Convenient loading - the best position
is left or right of kitchen sink.
. Opening that is square for proper
dishwasher operation and appearance.
*Cabinet front that is perpendicular
to floor.
1%”
(66 cm)
Minimum
heighl
- 24” (61 cm) 0
l Protection so that water inlet valve
and drain cannot freeze.
l %” minimum clearance between motor
and flooring to prevent the motor from
overheating.
Side view III
J
(52.7 cm)
20%” -;
2
Figure 2
3369671-C
(continued)