Recommended drain hose
connection methods:
Drain hose to air gap to waste tee.
k300096)
Rubber connect
Part No. 674361
/ Screw-
h type
20” 151 cm1
m Waste tee
t -1 - &mps
connector
&i;;lbmy j
clearance
to floor Entry mus - (1
it Part No.
6751491
f
be above
trap.
Drain hose to air gap to disposer.
above trap.
Install air gap (Part No. 300096)* according to kit instruc-
tions. If other brands of air gaps are used, they should be
checked to make sure they allow for the same water flow.
Connect the air gap to a waste tee (Part No. 675149)’ or
disposer using a rubber connector (Part No. 674381)*.
Most disposers have 7/e” connectors or special
connectors are available at plumbing supply houses.
Be sure to remove the disposer plug before
connecting the drain hose.
Alternate drain hose connection
methods:
Drain hose to waste tee.
Cut hose
Es-1
connector to fit.
-.
;;;;P;;m) ’
Lv7 I
clearance
to floor I 1
I Entry must be
I
above trap.
’ I
If local plumbing codes permit, dishwasher drain hose may
be connected directly to waste tee (Part No. 675149)‘. The
waste tee connection MUST be made ahead of the trap and
a minimum of 20 inches above the floor.
Drain hose to disposer.
- Do Not
y cut hose
connector.
.--. Screw-type
clearance I1
to floor
I
kzJ@”
E:try must be
above trap
If local plumbing codes permit, dishwasher drain hose
may be connected directly to a disposer. Most disposers
have 7/e” connectors or special connectors are available
at plumbing supply houses.
Be sure to remove the
disposer plug before connecting the drain hose.
*All parts are available through your dealer.
(continued)
3369671 -C