Whirlpool EH070CFXCO manual Troubleshooting, ChangingtheLightBulbs, PowerInterruptions, MovingCare

Models: EH070CFXCO

1 16
Download 16 pages 52.41 Kb
Page 6
Image 6
ChangingtheLightBulbs

7.Wash the inside walls with a solution of mild detergent in warm water or 2 tbs (26 mg) baking soda to 1 qt (0.95 L) warm water. Do not use abrasive or harsh cleaners.

8.Rinse well and wipe dry with a clean soft cloth.

9.Use a clean sponge or soft cloth and mild detergent in warm water to clean outside of freezer, door liner, and gasket.

10.Rinse well and wipe dry with a clean, soft cloth.

11.Wax painted metal surfaces on the outside of freezer to provide rust protection.

NOTE: Do not use wax on plastic parts. Wax may damage them.

12.For models with a defrost water drain, you should remove the hose adapter and replace the drain cover and the rubber stopper in the bottom of the freezer.

13.Replace all frozen food.

14.Plug in freezer or reconnect power.

15.Refer to “Using the Control” section.

ChangingtheLightBulbs

(onsomemodels)

To replace interior light:

1.Unplug freezer or disconnect power.

2.Reach behind the light lens to remove bulb.

3.Replace bulb with a 15-watt appliance bulb.

4.Plug in freezer or reconnect power.

To replace indicator light:

1.Unplug freezer or disconnect power.

2.Carefully snap out light cover and assembly with a screwdriver by inserting the edge of the screwdriver under the metal edge of the light cover.

3.Unplug burned out signal light and replace it with a new one.

NOTE: Indicator lights can be ordered from your designated service company.

4.Snap light cover and assembly into place.

5.Plug in freezer or reconnect power.

PowerInterruptions

If the power will be out for 24 hours or less, keep the door closed to help food stay cold and frozen.

If the power will be out for more than 24 hours, do one of the following:

Remove all frozen food and store it in a frozen food locker.

If a food locker is not available, consume or can perishable food at once.

After the power is restored, unplug the freezer for 30 minutes, to allow the refrigeration system to equalize. During this time keep the door closed whenever possible.

REMEMBER: A full freezer stays cold longer than a partially filled one. A freezer full of meat stays cold longer than a freezer full of baked goods. If you see that food contains ice crystals, it may be refrozen, although the quality and flavor may be affected. If the condition of the food is poor, dispose of it.

MovingCare

1.Remove all frozen food.

2.Unplug the freezer.

3.Clean it thoroughly.

4.Tape the freezer shut and tape the electrical cord to the cabinet.

When you get to your new home, refer to the “Installation Instructions” and “Freezer Use” sections for information on installation and setting the controls.

TROUBLESHOOTING

Try the solutions suggested here first to avoid the cost of an unnecessary service call.

Your freezer will not operate

To replace interior light:WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

Is the power supply cord unplugged? Plug into a grounded 3 prong outlet.

Has a household fuse blown or circuit breaker tripped? Replace the fuse or reset the circuit.

Is the temperature control set to a numbered setting? Refer to the “Using the Control” section.

6

Page 6
Image 6
Whirlpool EH070CFXCO Troubleshooting, ChangingtheLightBulbs, PowerInterruptions, MovingCare, To replace interior light