Whirlpool ETl8MK manual Moving the meat pan and cover, Removing crispers and crisper cover

2.Remove bulb.

3.Replace with a 40-watt appliance bulb.

Moving the meat pan and cover...

The meat pan can be taken out and moved the same way as the shelves. Remove the meat pan first.

.,. * ,r.i,?...__” lllc -s-a .-.--~l.--

To remove the meat pan and cover:

1.Slide the meat pan out to stop.

2.Lift the front of meat pan.

3.Slide pan the rest of the way out.

4.Tilt cover up at front.

5.Lift up at back.

6.Pull straight out.

TO STOP, LIFT THE

AND PULL AGAIN

HEAVY.

UL.

Adjusting the refrigerator shelves.,.

Shelves can be adjusted to match the way you use your refrigerator. Glass shelves are strong enough to hold bottles, milk and other heavy food items,

GLASS SHELVES ARE

HEAVY. BE CAREFUL.

To replace the meat pan and cover:

1.Guide the rear hooks of cover into the slots in the shelf supports.

2.Tilt up front of cover until rear hooks drop into slots. Lower front of cover to level position.

3.Replace meat pan in reverse order of removal.

I . ,. r . ..vr . +as,,..-7mm.

To remove glass shelves:

1.Tilt up at front.

2.Lift up at back.

3.Pull shelf straight out.

To replace glass shelves:

1.Guide the rear hooks into the slots in the shelf supports.

2. Tilt up front of shelf until hooks drop into slot. Lower front of shelf to level position.

Removing crispers and crisper cover...

PULL OUT TO STOP. LlFl THE FRONT

ND PULL AGAIN

To remove the crispers:

1. Slide crisper straight out to stop, lifl front, then slide the rest of the way out.

2. Replace in the reverse order.

REMOVE THE GLASS INSERT,

Lln THE FRAME FRONT, THEN THE BACK.

GLASS IS HEAVY. BE CAREFUL.

To remove the cover:

1.Push up glass insert from bottom, then slide out with both hands.

2.Lift front of cover frame.

3.Lift out cover frame by pulling up and out.

To replace the cover:

1.Fit back of cover into notch supports on walls of refrigerator, then lower front into place.

2.Replace cover support with the long tab to- wards the front. NOTE: If the support needs ad- justment, turn base right to raise, or left to lower.

3.Slide back of glass insert into place, then lower front.

6