Whirlpool GDP8500 warranty Adding a dish during a cycle, Cycle, Canceling a cycle

Adding a dish during a cycle

You can add a forgotten item to the dishwasher reaches LIGHT WASH. See page 8.

1.Lift up on the door latch to unlatch the door and stop the cyde. Wait a moment for the spray action to stop before open- ing the door.

2.Open the door and add the dish.

3.Close the door. Do not latch It. Wait 30

anytime before the Cycle Control knob

seconds for air in the dishwasher to warm up. Thii helps reduce the amount of moisture that can come from the vent when restarting the cycle.

4.Press door in to latch ft. The dishwasher will start where it stopped.

Changing

a cycle

setting

You can change a setting anytime during any cycle.

1. Lift up on the

door latch

tounlatch

the

NOTE: Turning

the

Cycle Control

knob

door and stop the cycle.

may cause

the

covered

section of the

2.

Turn the

Cycle Control

knob clockwise to

detergent

dispenser

to open.

Be sure to

the cycle

you

want.

fill the covered

section

if the

cycle

uses

3.

Push the

desired Cycle Selection button.

detergent

in both sections.

5. Close and latch the door. The dishwasher

4.

Check the detergent dispenser to be sure

will automatically start the new cycle.

it is properly filled for the new cycle. See

page 10.

Changing

an

option

You can change an option anytime during a cycle. To change the selected option(s):

1.Push the RESET OPTIONS button.

2.Push an Option Selector button for each desired option.

Canceling a cycle

You can cancel a cycle anytime during the cycle.

1.Turn the Cycle Control knob slowly clockwise to the drain portion of the wash or rinse. You will hear water draining when you have advanced to the proper location.

2.Let the dishwasher drain completely.

3.Lift up on the door latch to unlatch the door.

4.Turn the Cycle Control knob clockwise to point to OFF.