gramming tone
Each time you touch a pad you will hear a tone. If you don’t hear a tone, it is because the instruction is not correct, or because the tones have been removed.
EXAMPLE: If you touch a Number Pad before you touch a Command Pad, you will not hear a tone. The instruction is not correct.
If you want to remove the programmlng tone:
l Open the door.
l Touch CANCEL twice, then touch START.
l The tone will not sound for any touch.
Setting the clock
If you want to replace the programmlng tone:
l Open the door.
l Touch CANCEL lwlce, then touch START.
l The tone will sound for any correct touch.
If you want to remove all tones, except the mlnute timer slgnal:
l Open the door.
l Touch CANCEL twice, touch 0, then touch START.
l All audible tones will be cancelled.
l To replace the tones,
repeat the above steps.
When the oven is first plugged in, a tone sounds and the display shows 88:88. If the electric power ever goes off, the display will again show all 8’s when the power comes back on.
You can cook or use the Minute Timer without setting the’clock, but the display will be blank after cooking, however AUTO STARTwill not work unless the clock is set.
DO THIS... | THIS HAPPENS... |
.
m
1. Touch CLOCK SET.
2.Touch Number Pads for the correct time of day.
The Display will show a “0”and the colon will start to flash.The
first Number Pad must be touched wlthln 5 seconds or the Display will go blank. Touch CLOCK SETagain and continue.
The Display will show what numbers you touched in the order you touched them. This example shows 3:25.
The colon will stop flashing. The Clock is set.
3. Touch START.
If you have touched in an incorrect time, such as12:65, “Err”will show on the Display. Touch CLOCK SETand start over.
NOTE: To mtthe | clock, | touch | CLOCK SET.The | current time will show on the Dlspiay |
and the colon | will flash. | Set the | clock as shown | above. |
