Whirlpool RJE-3100, RJE-313P warranty Removing and Replacing Oven Control Knobs

Removing and Replacing Oven Control Knobs:

1Be sure the knobs are set to “OFF”

2 Pull each knob straight off.

3 Wash the knobs in warm.sudsy water.

4. The knobs are not interchangeable. Make sure you put the adjust- able Oven Temperature Control Knob on the right place. and the nonadjustable Oven Selector Knob on the other.

Removing surface units and reflector bowls:

First. be sure the Surface Unit Controls are all “OFF“and that the surface units are cool.

See where the surface units plug into the range? Lift each surface unit about an Inch (2.5 cm) at the edge away from the plug-in (receptacle). Pull the unit straight away from the plug-in. Do not wash surface units; they will burn themselves clean during nor- mal use.

Lift out the reflector bowls.

To remove surface unit. lift and pull straight out.

	Replacing reflector bowls and surface units:
	1	Be sure the surface unit controls are on “OFF.”
	;: Put the reflector bowls back into their places. Make sure you can see
Hold	surface unit level	the plug-ins (receptacles) for the surface units through the square
		hole in the side of each bowl.
when	replacing.
		Hold the surface unit level with the prongs (terminals) pointing at
	3.

the plug-in.

4. Wrth the prongs started in the plug-in. start pushing in on the surface unit. At the same time. lift a little on the side of the surface unit that’s by the plug-in.

5. Make sure the surface-unit prongs are pushed into the plug-in as far as they will go. The surface unit will fit into the reflector bowl and be level when everything has been done right.