Whirlpool RJE-313P, RJE-3100 warranty Easier cleaning with aluminum foil

				Easier cleaning with aluminum foil:
				Oven cleaning can be a chore when spillovers bake onto the
				bottom of the oven. Use aluminum foil so you can just throw it away with
				the spillovers. You can use the heavy-duty 18-inch (45 cm) aluminum foil
				found in most grocery stores. Or you can order an aluminum foil kit (Part
				Number 241430) from your Whirlpool Dealer.
				When cutting the foil. make sure it is long enough to cover the
				bottom with enough left over to start up both sides.
				Make sure the bake element is cool. Lift		it far enough to raise its feet
Foil	should	be	flat on	from	the bottom of the oven. (You	may	have to remove the
the	bottom	so	should	oven	rack. )
the feet on the element.				Slide	the foil sheet under the bake element.		Make sure it is centered
				and long enough to start up the sides.
				When you put the bake element back down, make sure all the feet
				rest solidly on the foil and that the foil is smoothed out across the
				bottom of the oven. If the feet on the element are not solidly on the
				foil. the oven may not bake properly.
				Cleaning	under the cooktop:
				To clean the area under the cooktop. lift the front of the cooktop at

Ithe center. Raise the swing-up rod to hold it. (Be sure the tip of the rod is

Prhp up the top with in the notch in the cooktop.) Use warm soapy water and a sponge or cloth.

support rod.Scouring powders or any other abrasive cleaner may harm porcelain-

enamel finishes and can scratch chrome.

Be careful not to raise the cooktop so high that it touches the control console. And don’t drop it. Dropping the cooktop can chip or crack a hard porcelain finish. or damage side panels and surface units.

Removing the oven door:

Removing the oven door may make it easier to clean the oven. To remove the door, first open it to the first stop (about 4 inches or 10 cm). Take hold of both sides of the door near the top; then lift it at the same angle it is in.

With the door off, you will notice how the ends of the hinges slide

Pull straight with the into slots at the bottom corners of the door. To put the door back on, fit

angle of part-open door. both bottom corners of the door over the ends of the hinges. Push the door down evenly. so neither corner gets ahead of the other. When it reaches the bottom, you can close the door. A safety latch will hold the door open until it is on correctly.

Push down evenly.

9