1. INSTALLATION

18.Check that fore marks are aligned, and fasten hex. nut (17), spring washer (18) and hex. bolt (19) tightly.

19.Fasten hex. nut (20), spring washer (21) and flat washers (22) removed at step 4 to stud bolt on the seachest cap.

-M12 hex. nut (20)

-M12 spring washer (21) -M12 flat washer (22)

Fore mark

(at the bottom

of the transducer)

The distance between the seachest cap (4) and flange (7) must be 5 mm.

Flange (7)

5 mm

Seachest cap (4)

How to open the gate valve

When you open or close the gate valve, unfasten two nuts shown below to rotate the handle. Then, fasten nuts to fix the handle.

1-15

Page 21
Image 21
Furuno DS-60 installation manual How to open the gate valve