1. INSTALLATION
9.Use M16 nut (11), spring washer (12) and flat washer (13) to fix the transducer (1) w/fixing plate to the fixing flange (4).
M16 hex. nut (11)
M16 spring washer (12)
M16 flat washer (13)
Transducer (1)
Fixing flange (4)
10.For the transducer
Hex. bolt (15) 
Seal washer (16)
Fixing plate (5)
1)Attach the grommet (supplied) to the location marked with a white line on the transducer cable.
2)Fix the grommet attached at step 1) to the notch shown below, by using the cable fixing plate (17), hex. bolt M6x12 (18), spring washer M6 (19).
3)Pass the connector at the end of the transducer cable between the transducer and M16 bolt, and attach the notch as shown below.
Transducer cable
Attach the connector to this notch.
Notch
(for grommet)
Pass the cable between the transducer and this bolt.
White mark
Grommet
Cable fixing plate (17)
M6 spring washer (19)
Hex. bolt M6x12 (18)
4)Connect the cable assy. (supplied) to the connector attached at step 3). Clean the connector faces and pins before the connection.
