Whirlpool RS576PXP warranty Using the SELF-CLEANING Cycle, Before YOU Start

Terminal

3.Hold the surface unit as level as possible

with the terminal just started into the

4.While pushing the surface unit terminal into

the receptacle, lift a little on the edge of the unit nearest the receptacle.

5.When the terminal is pushed into the re- ceptacle as far as it will go, the surface unit will fit into the reflector bowl.

Reflector bowls reflect heat back to the utensils on the surface units. They also help catch spills. When they are kept clean, they reflect heat better and look new longer.

If a reflector bowl gets discolored, some of the utensils used may not be flat enough. Or some may be too large for the surface unit. In either case, some of the heat that is meant to go into or around a utensil goes down and heats the reflector bowl. This ex- tra heat can discolor it.

USING THE SELF-CLEANING CYCLE

The self-cleaning cycle uses very you start, make sure you understand safely.

hlgh heat to burn away soil. Before exactly how to use the cycle

BEFORE YOU START

1. Clean areas that may not be cleaned during the cycle. Use hot water and deter- gent or a soapy steel-wool pad on...

l the frame around the oven

l the inside of the door, especially the part outside the oven seal.

DO NOT try to clean the tlberglass seal. DO

NOT move It or bend It.

Remove any pots or pans you may have stored in the oven. They can’t stand the

soil or grease. This will during the cleaning