Whirlpool SF315PEPB3 manual Cooktop Use, Cooktop Controls, Sealed Surface Burners, Power failure

Models: SF315PEPB3

1 48
Download 48 pages 36.75 Kb
Page 6
Image 6
COOKTOP USE

COOKTOP USE

Cooktop Controls

Cooktop ControlsWARNING

Fire Hazard

Do not let the burner flame extend beyond the edge of the pan.

Turn off all controls when not cooking.

Failure to follow these instructions can result in death or fire.

Electric igniters automatically light the surface burners when control knobs are turned to LITE.

Before setting a control knob, place filled cookware on the grate. Do not operate a burner using empty cookware or without cookware on the grate.

To Set Burner Temperature:

1.Push in and turn knob counterclockwise to LITE.

All four surface burners will click. Only the burner with the control knob turned to LITE will produce a flame.

2.Turn knob anywhere between HIGH and LOW. The clicking will stop. Use the following chart as a guide when setting heat levels.

SETTING

RECOMMENDED USE

 

 

 

LITE

Light the burner.

 

 

 

HI

Start food cooking.

 

Bring liquid to a boil.

 

 

MED

Hold a rapid boil.

 

Quickly brown or sear food.

 

Fry or sauté foods.

 

Cook soups, sauces and gravies.

 

Stew or steam foods.

 

 

 

LO

Keep food warm.

 

Melt chocolate or butter.

 

Simmer.

 

 

 

Power failure

In case of prolonged power failure, the surface burners can be lighted manually. Hold a lighted match near a burner and turn knob counterclockwise to LITE. After burner lights, turn knob to setting.

REMEMBER: When range is in use or (on some models) during the Self-Cleaning cycle, the entire cooktop area may become hot.

Sealed Surface Burners

A

B

C

 

 

D

 

E

A. Burner cap

D. Burner

B. Alignment pins

E. Gas tube opening

C. Igniter

 

IMPORTANT: Do not obstruct the flow of combustion and ventilation air around the burner grate edges.

Burner cap: Always keep the burner cap in place when using a surface burner. A clean burner cap will help prevent poor ignition and uneven flames. Always clean the burner cap after a spillover and routinely remove and clean the caps according to the “General Cleaning” section.

Gas tube opening: Gas must flow freely throughout the gas tube opening for the burner to light properly. Keep this area free of soil and do not allow spills, food, cleaning agents or any other material to enter the gas tube opening. Protect it from spillovers by always using a burner cap.

To Set Burner Temperature:APower failure

B

A.1-1¹⁄₂" (25-38 mm)

B.Burner ports

6

Page 6
Image 6
Whirlpool SF315PEPB3 manual Cooktop Use, Cooktop Controls, Sealed Surface Burners, To Set Burner Temperature, Power failure