BeforeYouStart...
IMPORTANT: Read and save these instructions.
It is recommended that this system be installed by a licensed plumber. It is the responsibility of the installer to comply with the installation specifications provided and with state and local plumbing codes.
If you decided to install the system yourself, see “General Information” on page 9 before continuing.
Water Filtration Svstems I. II and Ill can be installed in the basement if there is not adeqiate room for
DO NOT use filtration system if water is micro- biologically unsafe or water quality is unknown.
If you need assistance.. .
Refer to the Use & Care information at the end of this booklet. If you need more help, the Whirlpool Consumer Assistance Center will answer any questions you may have about operating or maintaining your water filtration system. The Whirlpool Consumer Assistance Center is open 24 hours a day, 7 days
a week. Just dial
WaterFiltration
SystemsI,II& 111
0 HOOK UP WATER
&Turn off cold water supply.
*Turn on faucet to drain water from line.
l Connect saddle valve to cold water suppty. Turn saddle valve handle clockwise until piercing lance enters pipe and stops.
*Connect one end of orange tubing lo saddle valve. Connect other end to filtration assemblv.
a‘SYSTEM CONNECTION
l Decide if the system will be connected to your refrigerator, to an optional faucet or to both.
l Connect refrigerator’s water supply to filtration assembly with blue tubing.
l Or, install faucet in sink and connect
connector to connect
