PROBLEM
Cooking
results are not what you expected
The display is flashing “88:88”
“F2” shows in the display
POSSIBLE CAUSE
The Oven Selector and Oven
Temperature Control Knob
are not set to CLEAN.
The range clock does not show the correct time of day.
The Lock Lever is not in the CLEAN
A delayed start time has been programmed.
The range is not level.
The oven temperature is too low or too high.
The oven was not preheated before baking.
The recipe has never been tested or is not from a reliable source.
The pan used is not the type or size recommended in the recipe.
There is not proper air circulation around pan when baking.
Cooking utensil does not fit the surface unit being used.
There has been a power failure.
SOLUTION
Set both the Oven Selector and Oven Temperature Control Knob to CLEAN.
Reset clock to show the correct time of day. (See page 12.)
Move Lock Lever all the way to the right.
Wait for the start time to be reached.
Level range. (See Installation Instruc- tions.)
See page 15 for instructions on how to adjust the Oven Temperature Control.
Preheat oven when called for in recipe.
Use only tested recipes from a reliable source.
Refer to a reliable cookbook for recommended pan type and size.
Allow 1% to 2 inches
(2.5 cm).
Pan should be the same size or slightly larger than surface unit being used.
Reset the clock. (See page 12.)
Call for service. (See Step 3 on page 44.)
43