Power Supply Cable Installation
1.For direct wire installations, run the home power supply cable according to the National Electric Code or CSA standards and local codes and ordinances. There must be enough wiring from the fused disconnect (or circuit breaker) box to make the connection in the hood electrical terminal box.
For optional power supply cord kit installations, follow the instructions in the “Make Electrical Connections” section.
NOTES:
■Do not reconnect power until the installation is complete.
■Use only with range hood cord connection kits that have been investigated and found acceptable for use with this model range hood.
2.Remove the screw from the terminal box cover. Remove terminal box cover and set aside.
A
B
A. Terminal box cover
B.Screw
3.Remove the power supply knockout from the top or rear of the vent hood (depending on the incoming location of your home power supply cable) and install a UL listed or CSA approved ¹⁄₂" strain relief.
A
A. Power supply knockout
4.Using 2 or more people, lift the hood into final position. Feed enough electrical wire through the ½" UL listed or CSA approved strain relief to make connections in the terminal box. Tighten the strain relief screws.
5.Position the range hood so that the large end of the keyhole slots are over the mounting screws. Then push the hood toward the wall so that the screws are in the neck of the slots. Tighten the mounting screws, making sure the screws are in the narrow neck of slots.
Make Electrical Connection
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1.Disconnect power.
|
| G |
C | D | E |
|
|
A 
B
F
A. White wires | E. Home power supply cable or | |
B. Black wires | power cord accessory kit | |
C. UL listed wire connector | F. UL listed or CSA approved | |
D. Green (or bare) ground wire | ½" strain relief | |
G. Green ground screw | ||
|
2.Use UL listed wire connectors and connect white wires (A) together.
3.Use UL listed wire connectors and connect black wires (B) together.
WARNING
Fire Hazard
Electrically ground the blower.
Use copper wire.
Connect ground wire to green ground screw in terminal box.
Failure to do so can result in death, fire, or electrical shock.
4.Connect green (or bare) ground wire from power supply to green ground screw in terminal box and securely tighten.
5.Install terminal box cover.
6.Reconnect power.
7
