Complete Installation
1.Install the 75W (max.) Incandescent light bulb. See “Replacing the Incandescent Light Bulb” in the “Range Hood Care” section.
2.Replace grease filter if removed. See the “Range Hood Care” section.
3.Check the operation of the range hood fan and light. See “Range Hood Use” section.
If range hood does not operate, check to see whether a circuit breaker has tripped or a household fuse has blown. Disconnect power and check wiring connections.
NOTE: To get the most efficient use from your new range hood, read the “Range Hood Use” section.
RANGE HOOD USE
The range hood is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the hood before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from the kitchen.
The hood controls are located on the top of the range hood.
A
BC
A.Incandescent light housing and cover
B.Charcoal filter retainer
C.Grease filter
Range Hood Controls
Off
On | Off | Low | High |
AB
A. On/Off light switch
B. Fan speed switch
Operating the light
Push the light switch to the right to turn the light Off. Push the light switch to the left to the turn the light On.
Operating the fan
Push the fan switch to the left for Low speed. Push the fan switch to the right for High speed. Push the fan switch to the middle for Off.
RANGE HOOD CARE
Cleaning
IMPORTANT: Clean the hood and grease filters frequently according to the following instructions. Replace grease filter before operating hood.
Exterior Surfaces:
IMPORTANT: Do not use
To avoid damage to the stainless steel, do not use cleaners that contain chlorine.
Cleaning Method:
■Rub in direction of grain to avoid scratching or damaging the surface.
■For stainless steel models, Stainless Steel Cleaner and Polish Part Number 31462A (not included): See “Assistance or Service” section to order.
■Liquid detergent or
Rinse with clean water and dry with soft,
■Glass cleaner to remove fingerprints.
Charcoal Filter
The charcoal filter is not washable. It should last up to 6 months with normal use.
Replace the old charcoal filter with a new charcoal filter. For information on ordering, see the “Accessories” section.
To replace filter:
1.Remove screw from the filter retainer.
2.Turn the filter retainer to release filter.
A
A. Filter retainer
3.Reinstall the filter by placing the back edge in the channel at rear of hood. Push filter into place, turn the filter retainer to secure filter to range hood.
4.Replace screw in the filter retainer.
8
