Whirlpool W10018010 Range Hood Use, Check Operation, Install Filters, Range Hood Control Panel

When fitting the cover, check that the side rails fit in the proper head-screws (those used to fix the lower vent cover to the hood) on the right and left side of the duct.

To replace the metal grease filters:

1.Insert back edge of filter into rear channel of the filter opening.

2.Push handle toward the rear and push filter up.

3.Pull filter toward the front and insert into front channel.

Check Operation

AB

C

Rear view

A. Lower vent cover screws

B. Glass visor

C. Aesthetic cover

Install Filters

For non-vented (recirculating) installations

1.Turn off blower and lights. Check that halogen lamps are cool.

2.Remove the metal grease filters by pushing handle toward the rear and pull downward.

3.Pull filter toward front.

4.Set the filter face down on a protective cover such as a towel.

5.Install charcoal filter on rear of metal filter with metal wires provided in filter packaging.

A	B	C	D	E
A. Indicator light		D. Medium speed button
B. Light button		E. High speed button
C. Low speed button

1.Press the “B” button. The light should turn on.

2.Press the “C” button. The blower should turn on at low speed.

3.Press the “D” button for medium speed or the “E” button for high speed.

4.Press the “B” button to turn off the light. Press the “C” button to turn off blower

5.If range hood does not operate, check to see whether a circuit breaker has tripped or a household fuse has blown.

6.Disconnect power supply.

7.Check that the wiring is correct.

8.Replace all parts and panels before operating.

9.Reconnect power.

NOTE: To get the most efficient use from your new range hood, read the “Range Hood Use” section.

RANGE HOOD USE

Operation

The canopy hood is designed to remove smoke, cooking vapors and odors from the cooktop area. For best results, start the hood before cooking and allow it to operate several minutes after the cooking is complete to clear all smoke and odors from the kitchen.

Range Hood Control Panel

The range hood controls are located on the underside of the canopy.

	A	B	C	D	E
A	A. Indicator light		D. Medium speed button
	B. Light button		E. High speed button
	C. Low speed button
B	C
	Operating the light

1. Press the “B” button to turn on the light.

2. Press the “B” button again to turn off the light.

Operating the blower and adjusting blower speed

A. Metal wires B. Charcoal filter C. Metal filter

1.Press the “C” button for low speed, the “D” button for medium speed or the “E” button for high speed.

2.Press the “C” button to turn off the blower.

10