Level and Exhaust the Dryer
Dryer must be level to reduce noise and assure proper performance.
Slide dryer onto cardboard or hardboard before moving across floor to prevent floor damage.
1.Move dryer close to its permanent location. Leave enough room to connect exhaust vent. Remove cardboard or hardboard from under dryer.
2.Check levelness of dryer by placing a level on top of dryer, first side to side, then front to back. If dryer is not level, adjust dryer legs up or down.
3.If legs are not long enough to level dryer, order Extended Dryer Feet Kit, Part No. 279810 (sold two legs per kit), from your dealer.
4.Connect exhaust vent to exhaust outlet in dryer. The exhaust vent must fit over the dryer exhaust outlet and inside the exhaust hood vent.
Use 10.2 cm (4") vent clamps to seal all joints and to secure exhaust vent to dryer exhaust outlet.
10.2 cm (4") 
clamp 
10.2 cm (4")
clamp
5.Move dryer into final position.
10
