Electrical Requirements | Gas Requirements |
Important: Observe all governing codes and ordinances.
This dryer is supplied/fitted with an electricity supply cord and plug. It should be connected to electricity supply socket at the voltage shown on the rating plate. The minimum supply fuse capacity should be 5A. The dryer must be positioned so that the plug is accessible. If the fitted plug is not used, the electrical connection must be carried out by a competent electrician in accordance with local or national codes.
If the supply cord is damaged, it must be replaced with a specially terminated cord by an authorized service agent or a similarly competent person.
Do not use an adapter.
Do not use an extension cord.
WARNING
Electric Shock Hazard
This is a
Do not earth to a gas pipe.
Do not change the power supply cord plug. If it does not fit the outlet, have a proper outlet installed by a qualified electrician.
Do not use an extension cord with this dryer.
Failure to follow these instructions could result in death, fire, or serious injury.
If codes permit and an additional earth bond wire is used, it is recommended that a qualified electrician determine that the earth bond, path is adequate.
WARNING
Explosion Hazard
Connect this dryer to a regulated gas supply. Supply pressure must be in accordance with the Technical Specifications (see last page).
Install a
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure gas pressure is correct.
Failure to do so can result in death, explosion, or fire.
OBSERVE ALL GOVERNING CODES AND ORDINANCES.
Gas supply:
Check that dryer is equipped with the correct burner for the particular type of gas supply. Burner information will be found on the model/serial rating plate in the door well of the dryer. If this information does not agree with the type of gas available, see your dealer.
Natural Gas:
This dryer is factory adjusted for use with NATURAL GAS (G20), and no further adjustment should be required at installation.
L.P. Gas:
This dryer is also certified for use with L.P (propane or butane) gases with appropriate conversion. No attempt shall be made to convert the appliance from the gas specified on the model/serial rating plate for use with a different gas without consulting the serving gas supplier.
Conversion must be done by a competent service technician. Gas conversion kit, part number 279918, is available for purchase from your dealer. Full instructions are supplied with the kit.
6
