6
INSTALLATIONINSTRUCTIONS

Before You Start

NOTE: To avoid floordamage during installation, set the washer
onto cardboard before moving across floor.
IMPORTANT:
Be sure the foam shipping base has beenremoved from the
bottom of the washer as directed in the Unpacking
Instructions.
If foam shippingbase h as not been removed,be sure lid is
secured with tape before laying washer on its back.
Removing the foamshipping base is necessary for proper
operation.

RemoveShipping Base and Packing Ring

1. Place cardboard supports from shipping carton on floor
behind washer for support.
2. Secure the lidwith tape.
3. Using2 or more people, tip the washer onto its backand
placeon cardboard supports.
4. Remove foam shipping base.
5. Set washer upright.
6. Remove tape from lid. Open lid and remove foam packing
ring fromwasher tub. Keep foam packing ring in case you
needto move the washer in the future.

Connect Drain Hose

Proper connection ofthe drain hose protects your floors from
damagedu e to water leakage. Read and follow these
instructions.
The drain hose is connectedto your washer and is stored inside
the washer cabinet.

Remove drain hose from washercabinet

Pull the corrugateddrain hose out of the washer by first grabbing
the pull tie. Continue to pull the hose untilthe end emerges. Do
not forceexcess drain hose back into the rear of the washer.
WARNING
Excessive Weight Hazard
Use two or more people to move and install washer.
Failureto do so can result in back or other injury.