7
Laundrytub drain or standpipe drain
Connecting the drain hose formto the corrugated
drainhose
To ke ep drain water from going back into thewasher:
Do not force excess drain hose into standpipe.Hose should
bes ecure but loose enough to provide a gapfor air.
Do not lay excess hose on the bottomof the laundry tub.
Floordrain
Do not install the drain hose form on to the corrugated drain
hose.You may need additional parts. See Floor drain under
“Tools and Parts.”
Connect the Inlet Hoses1. Insert new flat washers (supplied) into eachend of the inlet
hoses. Firmlyseat the washers in the couplings.
Connect theinlet hoses to thewater faucets
Makesure the washer basket is empty.
2. Attach the hose labeled hot to the hot water faucet. Screw
oncoupling by hand until it is seated on the washer.
3. Attach the hose labeled cold to the cold water faucet. Screw
oncoupling by hand until it is seated on the washer.
4. Using pliers, tighten the couplings with an additional
two-thirds turn.
NOTE: Do not overtighten or use tape or sealants on the
valve. Damage to the valves can result.
Clear thewater lines
Run water through both faucets and inlet hoses, into a
laundry tub,drainpipe or bucket, to get rid of particles in the
water lines that might clogthe inlet valve screens.
Checkthe temperature of the water to make sure that the hot
water hose is connected to the hot water faucet and that the
cold waterhose is connected to the cold water faucet.
Connect theinlet hoses to thewasher
1. Attachthe hot water hose to the inlet valve labeled hot.
2. Attaching one hose coupling first makes it easier to tighten
the connectionw ith pliers.
3. Screw on couplingby hand until it is seated on the washer.
A.Dr ain hose reliefs
1.Feed end of drain hose into one end of form. Place end of drain
hoseform into the drain hose relief.
2.Bend the hose over the top of the form and feed into the other end
ofthe form. Attach the other end of the form into the other drain
hoserelief. The hose must extend 4½ " (114 mm) beyond the form.
A.Coupling
B.Washer
4.5"
(114mm)
A
AB
Tighten thecouplings with an addit ional two-thirds turn.
A.Hot water inlet valve
B.Cold water inlet valve
HOTCOLD
AB
COLD
HOT