Whirlpool WHAB-6015 Filtration System Accessories, Flow Monitor, Faucet Features, Faucet Care

12. Open the main water line valve. Check all connections for leaks.

IMPORTANT:

Before using the filtration system, follow the flushing procedure in the “Flushing Filtration System” section.

FILTRATION SYSTEM

ACCESSORIES

Replacement parts

To know your nearest dealer to buy a replacement filter, call 1-866-363-9472 and ask for the part number listed below.

UltraEase™ replacement filter cartridge – Sediment (Unit A): Part number #WHAB-6009

UltraEase™ replacement filter cartridge – Taste/lead/cyst (Unit B): Part number #WHAB-6010

UltraEase™ replacement filter cartridge – Chemicals, VOC’s (Unit C): Part number #WHAB-6011

WHAB-6009 WHAB-6010 WHAB-6011

FLOW MONITOR

The flow monitor indicates when it’s time to change your filters. The green light indicates the filtration is good. The yellow light indicates the filtration is fair. The red light tells you it is time to change your filter. You will need to replace the filter(s) cartridge(s) and the two AA batteries in the flow monitor (included with replacement filter B, WHAB-6010 and replacement filter C, WHAB-6011).

FAUCET FEATURES

(WHAB-6014, WHAB-6015 models only)

Vegetable sprayer

These two models feature a vegetable sprayer. When needed, pull down the sprayer to get a mist spray. For a regular flow, push the sprayer up.

FAUCET CARE

(WHAB-6014, WHAB-6015 models only)

Cleaning

If you have very hard water, and you notice that the water flow is reduced, it may be necessary to clean the spout screen.

1.Use a small brush and vinegar to remove hard-water deposit.

2.Turn on/off handle to run water briefly to remove vinegar and deposits from screen.

FLUSHING

THE FITRATION SYSTEM

Before using the filtration system, follow these steps.

1.First make sure the new filters are in place and the water supply is on.

2.Flush the filters by opening the sink faucet and letting the water run for approximately 5 minutes. The water will be dark grey or charcoal colored for a few minutes until the water is clear.

NOTE: Do not drink water until it runs clear.

BEFORE CALLING

FOR SERVICE...

The filter is expected to last 12 months depending on local water conditions and the volume of water used. We recommend you change your filter approximately every 12 months, however, it can be replaced earlier if there is a drop in water pressure at the faucet.

If the faucet does not operate, check these points first:

Has the water supply been turned off?

Check all tubing connections for proper installation.

Make sure filters are intalled properly.

12