Customizing Features / Options
RECHARGE
The RECHARGE button is used to initiate an immedi- ate recharge.
1. Press and hold the RECHARGE button until the words “RECHARGE", “SERVICE" and “FILL" flash in the display.
FIG. 20
RECHARGE initiated
The softener enters the fill cycle of regeneration right away. “RECHARGE” will flash during the regenera- tion. When completed, full water conditioning capaci- ty is restored. While water softener is running a recharge, the time remaining until the recharge is completed will show in the display during all cycles except for the Fill cycle.
NOTE: Avoid using hot water while the softener is regenerating, because the water heater will refill with bypass hard water.
RECHARGE SCHEDULED
If you do not want to start an immediate recharge, but would like to schedule an extra recharge at the next preset recharge time, do the following:
1. Press and release (do not hold) the RECHARGE button.
FIG. 21
RECHARGE scheduled
The words “RECHARGE SCHEDULED" flash in the display, and the softener will recharge at the next recharge time. The word “RECHARGE" will flash dur- ing the regeneration. When completed, full water conditioning capacity is restored.
SET SALT LEVEL
The water softener has a salt monitor indicator light to remind you to add salt to the storage tank.
NOTE: You must set salt level each time salt is added to the water softener.
To set this monitor system:
1. Lift the salt hole cover and level the salt in the stor- age tank.
2. The salt level decal, on the brinewell inside the tank, has numbers from 0 to 8. Observe the high- est number the leveled salt is at, or closest to.
3. Press the SET SALT LEVEL button until black ovals correspond to the salt level number (See Figure 22). At level 2 or below, the “Check Salt Level" LED indicator will flash.
FIG. 22
If you want to turn the salt monitor off, press the SET SALT LEVEL button until “SALT LEVEL OFF” shows in the display (See Figure 23).
FIG. 23
TANK LIGHT
The water softener is equipped with a tank light for viewing the salt level in the brine tank. Push the tank light button on the electronic control once, and the tank light will turn on. Pushing the tank light button again will turn the light off. The tank light will auto- matically turn off after a period of four minutes if the tank light button is not used to turn it off.
14
