Whirlpool whirlpool manual Troubleshooting, Refrigerator Operation

Moving

When you are moving your refrigerator to a new home, follow	4.	Turn off the Temperature control(s). See “Using the Control(s).”
these steps to prepare it for the move.	5.	Unplug refrigerator.
1. If your refrigerator has an automatic ice maker:
	6.	Clean, wipe, and dry thoroughly.
■ Turn off the water supply to the ice maker at least one day
	7.	Take out all removable parts, wrap them well, and tape them
ahead of time.
		together so they don’t shift and rattle during the move.
■ Disconnect the water line from the back of the refrigerator.	8.	Depending on the model, raise the front of the refrigerator so it
■ When the last load of ice drops, raise the wire shutoff arm		rolls more easily OR raise the leveling screws so they don't
		scrape the floor. See “Adjust the Door(s).”
to the OFF (up) position or press the switch to OFF,
depending on your model.	9.	Tape the doors closed and tape the power cord to the back of
2. Remove all food from the refrigerator and pack all frozen food		the refrigerator.
	When you get to your new home, put everything back and refer to
in dry ice.
3. Empty the ice bin.	the “Installation Instructions” section for preparation instructions.
	Also, if your refrigerator has an automatic ice maker, remember to

reconnect the water supply to the refrigerator.

TROUBLESHOOTING

Try the solutions suggested here first before calling for assistance.

Refrigerator Operation

The refrigerator will not operate

WARNING

Electrical Shock Hazard

Plug into a grounded 3 prong outlet.

Do not remove ground prong.

Do not use an adapter.

Do not use an extension cord.

Failure to follow these instructions can result in death, fire, or electrical shock.

■Power cord unplugged? Plug into a grounded 3 prong outlet.

■Outlet working? Plug in a lamp to see if the outlet is working.

■Household fuse blown or circuit breaker tripped? Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician.

■Controls on? Make sure the refrigerator controls are on. See “Using the Control(s).”

■New installation? Allow 24 hours following installation for the refrigerator to cool completely.

NOTE: Adjusting the temperature controls to coldest setting will not cool either compartment more quickly.

The motor seems to run too much

Your new refrigerator may run longer than your old one due to its high-efficiency compressor and fans. The unit may run even longer if the room is warm, a large food load is added, doors are opened often, or if the doors have been left open.

The refrigerator seems noisy

Refrigerator noise has been reduced over the years. Due to this reduction, you may hear intermittent noises from your new refrigerator that you did not notice from your old model. Below are listed some normal sounds with explanations.

■Buzzing - heard when the water valve opens to fill the ice maker

■Pulsating - fans/compressor adjusting to optimize performance

■Hissing/Rattling - flow of refrigerant, movement of water lines, or from items placed on top of the refrigerator

■Sizzling/Gurgling - water dripping on the heater during defrost cycle

■Popping - contraction/expansion of inside walls, especially during initial cool-down

■Water running - may be heard when ice melts during the defrost cycle and water runs into the drain pan

■Creaking/Cracking - occurs as ice is being ejected from the ice maker mold.

The doors will not close completely

■Door blocked open? Move food packages away from door.

■Bin or shelf in the way? Push bin or shelf back in the correct position.

21