Whirlpool WSR413YW0 manual UsingyourROwaterfiltrationsystem, MaintainingyourROwatersystem

UsingyourROwaterfiltrationsystem

To get purified water from the storage tank - Hold the faucet handle down for momentary flow, hold the faucet up for continuous flow.

To stop water flow from the faucet - Return the faucet to the center or horizontal position.

When faucet flow slows or drips - The storage tank is empty. Wait 1 hour before dispensing any additional water.

Ways purified water can be used - Your water filtra-

Replacingfilter cartridges-sediment andCarboncartridges

1.Turn off water supply to RO system either at the saddle valve or cold water valve. Open faucet to drain tank. Wait five minutes for filtration assembly to depressurize.

2.Lift cover off of filtration assem-

bly. Rotate cartridge l/4 turn to the left to remove connector tabs from receptacle. Gently pull down to

4.Remove RO membrane cartridge from plastic bag. Hold the RO cartridge over the sink. Push in the grey push-in connector and hold; then pull short white plug out of connector and discard.

5.Remove red cap from top of new RO cartridge. Allow preservative from cartridge to drain into sink.

Rinse off the car-

tridge with tap water0

and dry with a paper	o-ring
	seals
towel. Wet O-ring	f
seals with a little	tabs

tion system has many uses, including:

remove cartridge.

eptacle

water. Reinsert red tubing into

l	Drinking		water	l	Cooking water
l	Ice cubes			l	Mixing baby	formula
l	Watering		plants	l	Pet drinking	water
l	Steam	irons		l	Aquarium
l	Hand	washing		dishes

MaintainingyourROwatersystem

How often RO Membrane, Sediment and Carbon cartridges need to be replaced will depend on local water conditions including dirt, iron and chlorine levels. Private wells may require more frequent cartridge replacement while softened water systems may only require cartridge replacement once a year. The maxi- mum length of time a filter cartridge should be used is one year. Special water conditions where contaminants are known should be regularly monitored by a public health agency.

The RO membrane filter cartridge should be replaced when indicator light changes from green to yellow. The naximum length of time a RO membrane filter cartridge should be used is three years.

Cartridge				Replace at least		Or replace			if or		when...
Sediment				Once/year		-Water	sup ly is cloudy
(1st	on	right)				has high2 rrt and rust
						content		change			every
						six mont I, s)
						-Water	amount			or
						flow	from		faucet		is
						noticeably			reduced
Carbon			right)	Once/year		-Water	supply			smells
(2nd	from					of chlorine			or water
						has high dirt and rust
				!		content		fchanoe			every
RO	membrane				1	six months)				-	’
						- Indicator			light
[3rd	from		right)			changes			from
						green	to	yellow,,
						even	after		drarnrng
						tank	twice
Carbon		Block		Once/year		- Water has “off” taste
:4lh	from		right)			or odor

laintenance of this water fillration system is very important. Replace the Sediment 6). GAC Carbon (GAC) and Carbon Block (C%) cartridges annuaky.‘tieplace the TFCM iembrane (RO) car- tridge when the indicator disk light turns yellow. Failure to main- tain this waler filtration system over an extended period of time could present health risks

3. Check that label on new

cartridge matches label above

cartridge receptacle. RemoveYcartrldge red cap from cartridge. Wet O-ring

seals of new cartridge with a little water. Line up the tabs at the top of the new cartridge with the slots in

the filtration assembly’s receptacle. Push cartridge up and turn it l/4 turn to the right to lock it into place. Cartridge label must face front. Pull down on cartridge to make sure it’s firmly in place. Repeat step if car- tridge disconnects.

4. Turn on water supply. Open
faucet and allow water to run for		carlridge
2 minutes to check system for
leaks. If water is leaking, shut off	I	I

water and recheck connections. Replace cover.

ReplacingROmembranecartridge

1.When indicator light changes from green to yellow, turn off water supply, open faucet to drain tank and turn off saddle valve. Wait five minutes for filtration assembly to depressurize.

2.Lift cover off of filtra- connector

tion assembly. Push in the grey push-in connector near bottom of RO cartridge and remove tubin

3.Rotate bad RO cartridge l/4 to the left to remove connector from receptacle. Gently pull dow

remove cartridge.

15

push-in connector of new RO ‘B

cartridge.

6.Line up the tabs at the top of the RO cartridge with the slots in the filtration assembly’s recep- tacle. Push cartridge up and turn it l/4 turn to the right to lock it into place. Cartridge

label must face front. Pull down on cartridge to make sure it’s firmly in place. Repeat step if fil- ter disconnects.

7.Turn on water supply. Open faucet and allow water to run

for 2 minutes to check system for leaks. If water leaks, shut off water and recheck connections. Replace cover.

Howto sanitizeROsystem

You will need new Sediment and Granular Activated Carbon cartridges, household bleach and eyedropper.

1.Turn off saddle valve in water line. Open faucet and drain tank. There will be no water dripping when tank is completely empty.

2.Remove Sediment and Granular Activated Carbon cartridges.

3.Remove caps from new cartridges. Insert new Sediment cartridge into receptacle with symbol that matches the one on label.

4.Use eyedropper to

inject 1 teaspoon (5ml) of bleach into hole in top of new Granular Activated Carbon cartridge. Insert cartridge into receptacle matches the one on label.

5.Turn on saddle valve in water line. Wait

6hours before using system. Open faucet and drain tank. There will be water dripping when tank is empty. Allow tank to refill. If water has a taste, drain tank and allow it to refill again.