TW2000
2.7Control System
The Kerr TW2000 boiler control system serves the following functions:
1.Maintaining the boiler water temperature by controlling the combustion air entering the boiler. A double pole, double throw aquastat and the air damper control this function.
2.Protects the Kerr TW2000 boiler from an overfire by overriding the home’s thermostat and by putting any excess heat into the living area. Opening the “normally open
3.To allow the Kerr TW2000 boiler to operate as a gravity heating system in the event of a power failure, the “normally open
4.Kerr TW2000 boiler
IMPORTANT: Upon completion of the installation, a change over from one fuel to the other shall not require manual adjustment of any controls other than the thermostat.
2.8Wiring
The wiring diagrams for the controls on the Kerr TW2000 boiler are shown in Figures
NOTE: Most
To install the boiler as a free standing unit see Fig.
NOTE: The aquastat may be marked “High” and “Low” opposite the diagrams. The diagrams are correct.
ALL ELECTRICAL WIRING MUST CONFORM TO NATIONAL AND LOCAL CODES.
TW2000 | 17 | 10/6/05 |