USING THE CHG 200A BATTERY CHARGER
1.Plug the CHG 200’s power supply into the Power Input on the charger’s side and a standard AC wall outlet.
2.Route the power cord around the Cord Hook (see fig- ure at right). This will minimize strain on the cord and jack and insure that the power cord is not detached during charging.
3.Make sure the transmitter or receiver units to be charged are turned OFF.
4.Place the transmitters/receivers in the slots so that the CHG 200’s Charging Pins and units’ side panel con- tacts are coupled. Make sure that the charging contact holes line up with the charging pins. The transmitters/receivers should drop easily into the slots.
DO NOT FORCE THEM IN BACKWARDS.
5.The Charging Indicators will light, indicating that charging is in process. It takes
Further Suggestions
•Receivers and transmitters SHOULD NOT be left charging continuously when not in use. Receivers and transmitters should always be turned OFF while charg- ing.
FIGURE 9: USING THE CHG 200A BATTERY |
CHARGER |
Charging |
Contact Holes |
Charging |
Indicators |
Charging |
Pins |
Cord Hook |
Power Input |
•It’s best to allow the batteries to fully discharge before charging.
•If the batteries are near end of life and the LED turns off while the receiver is operating, this is an indication to change or recharge your batteries. Approximately one hour of battery life remains.
•Repeatedly charging the batteries after short periods of use
•Rechargeable batteries will need to be replaced after
!! IMPORTANT WARNINGS !!
DO NOT ATTEMPT TO RECHARGE ZINC CARBON (“HEAVY DUTY”), ALKALINE, OR LITHIUM BATTERIES!
DO NOT ATTEMPT TO RECHARGE DISPOSABLE BATTERIES. The batteries may heat up and burst, causing possible injury and damage to the equipment.
Avoid shorting the plus and minus battery terminals together with metal objects. Battery damage and burns can result!
Use only Williams Sound supplied chargers and batteries.
Williams Sound ® | 11 |
Helping People Hear
