Williams Sound CFM 300, CFM 400 user manual Optional Mounting Kits, SB-3 WALL/CEILING Mount

OPTIONAL MOUNTING KITS

Williams Sound offers two optional mounting kits for use with the SoundFocus FM System. Use the SB-3 Wall/Ceiling Mount Kit to mount an R800 Receiver or SPK 800 Speaker to a wall or ceiling. The SS-3 Floor Stand Kit includes an adjustable stand and flange which allow you to elevate the R800 or SPK 800 as you choose. To order these optional compo- nents, contact your dealer or Williams Sound Corp.

INSTALLING THE SB-3 WALL/CEILING MOUNT KIT

1.Use the 5/32" allen wrench to loosen the tension screw in the Clamp Assembly enough to release the ball. DO NOT unscrew the tension screw completely.

2.Position the Clamp Plate LENGTHWISE on the BOTTOM of the R800 Receiver or SPK 800 Speaker. (See Figure 15.) Mark TWO hole locations for drilling.

FIG. 15: SB-3 WALL/CEILING MOUNT

	Mounting Plate
	Ballshaft
	Clamp Plate
To Wall
Or	To Base Of
Ceiling
	R800 Or
	SPK 800
	Jaw
	Tension Screw

FIG. 16: CLAMP PLATE PLACEMENT

Front Of

R800/SPK 800

Clamp Plate

Placement

Bottom of

R800/SPK 800

3.Using your hole markings as a guide, drill TWO pilot holes using a 3/16" bit.

Caution: The receiver/speaker walls are 1/4" thick. Drill only deep enough to pass through the enclosure wall and no more than 1".

4.Attach the Clamp Plate to the receiver/speaker, using the two screws provided.

5.Using the Wall/Ceiling Mounting Plate as a template, mark TWO holes on the wall, ceiling, or other surface upon which you will be mounting the R800 or SPK 800. (See Figures 16 and 17.)

6.Drill TWO pilot holes.

7.Use fasteners appropriate for the mounting surface (wood screws, lag bolts, wall anchors) to attach the Mounting Plate. Recommended fastener size is 1/4".

8.Place the Receiver–Clamp Plate Assembly onto the the Mounting Plate ballshaft. Aim the receiver/speaker at the desired angle and support it fully while using the hex wrench to tighten the tension screw.

After initial installation, the ball will slowly compress under pressure. Check the ten- sion screw after 15 minutes and re-tighten if necessary. DO NOT OVER TIGHTEN.

Williams Sound ® 17

Helping People Hear