PERIODIC MAINTENANCE
Twice a month, flush a white vinegar solution (One quart vinegar to two gallons of water) or anti- browning solution (mixed as directed) through the extractor. This will prevent
NOTE: Do not use pins, wire, etc. to clean nozzles as this could destroy spray pattern.
Periodically inspect all hoses, electrical cables and connections on your machine. Frayed or cracked hoses should be repaired or replaced to eliminate vacuum or solution pressure loss. If the cable insulation is broken or frayed, repair or replace it immediately. Don’t take chances with electrical fire or shock.
MAINTENANCE
DAILY / REGULAR MAINTENANCE
Before making any adjustments or repairs to the machine, disconnect the power cord from electrical source.
1.Empty unused cleaning solution from the solution tank.
2.Inspect and clean filter screen in solution tank.
3.Flush pumping system with 4 or 7 liters of clean, hot water.
4.After each use, rinse tank with fresh water. Periodically inspect the recovery tank and decontaminate if necessary, using a Hospital Grade Virucide or a
5.Check for and remove any lint or debris around vac shoe.
6.Check spray jets for full spray pattern.
7.Remove lint and dirt
a.To remove brush, grab and pull brush out from end opposite drive belt (operator’s right). Remove other end from brush driver.
b.To install brush, line up slots in brush core with pin in driver on drive belt side (operator’s left) and push brush onto driver. Then snap bearing end (opposite end) of brush into retaining clip.
8.Check cooling air screen (located on frame behind left wheel) for lint or debris.
9.Check float and
NOTE: Always store machine with brush in “Store” position.
86038280 04/04/07 |
