Windsor D250 (115V) manual Operations, Carpet Inspection, Accessories, General Information

CARPET INSPECTION:

Determine precisely what areas you are going to clean. Note problem areas in the carpet or tack strip. Look for loose carpet, heavily damaged areas, discolored stains, or grease spots that will require prespotting. Note the carpet type. Check the availability of hot water, drains, and suitable electrical outlets. If the carpet is loose or worn, have it repaired before attempting to clean it.

Plan the cleaning route, work from the most remote area towards the exit. Try not to travel over the cleaned areas when getting fresh water or dumping old. Furniture should be moved out away from the walls before cleaning. If furniture is moved back in place before carpet is completely dry, place plastic or foil protectors under the legs to prevent possible carpet staining. When possible use a Windblower (WB3) and open all windows and doors to speed carpet drying.

ACCESSORIES:

The D-250 can be used with the following Windsor equipment: Deluxe Hand Tool (DHT), Pile Jogger(PJ2A), Standard Floor Wands(SFW, SW, SW-PRO, PROW), & Wind Blower carpet dryer(WB3). Contact an authorized Windsor dealer for assistance in choosing the right equipment .

GENERAL INFORMATION:

On heavily soiled carpets, or on areas of high foot traffic, it may be necessary to use a prespray

or traffic lane cleaner applied with a Pro-Spray. Do not add presprays to the machine's solution tank. If a spotter is used, follow the manufacturer's instructions exactly as printed on the label. Remove the spotter with the floor tool when done, spotter left in the carpet may bleach or brown it permanently.

As the carpet is being cleaned, check to see if there is foam building up in the recovery bucket. Add a little defoaming compound to the recovery tank but never to the solution tank.

For infrequent use or long periods of storage, flush the system with a neutralizing

solution of 1 quart white vinegar mixed with 2 gallons hot water. Flush the system with clean hot water after neutralizing.

For hose fitting lubrication, use a light

silicone lubricant which will not damage o-rings.

OPERATIONS

PROTECT THIS MACHINE FROM FREEZING.

EQUIPMENT SET-UP:

1.) Plug power cable from machine into

properly grounded wall outlet.

2.) Turn vacuum motor switch on and off to make sure there is electrical power at machine.

3.) Connect vac hose to machine. Slide the swivel cuff over the outlet on the tank.

4.) Connect the hose set to the machine and

wand. Pull back the knurled collar on the quick disconnect coupler and push onto the connection on the chassis. To avoid leaks, check to be sure a positive connection was made.

5.) Pour clean, hot water into the solution tank.

To avoid possible tank distortion, water temperature must not exceed 140 F (60C).

6.) Add a non-foaming cleaning solution

concentrate, for use in hot water extractors at the proportions noted on the container (See list below), into solution tank. NOTE: When using

powder cleaner, pre-mix with hot water in a clean container before adding to the solution tank.

7.) Turn pump and vacuum switch(s) to the on

position. NOTE: Pump may have to be primed for solution flow. (See Priming the Pump)

8.) Start cleaning.

PRIMING THE PUMP

1.Connect priming hose to solution output on machine.

2.Run open end of priming hose to vacuum intake.

3.Turn pump and both vacuums on and seal off hose going into vacuum in take.

4.Do this for 30 seconds or until pump is putting out a steady flow of water.

D-250 98828 04/08/03 4