NORMAL SCRUBBING
Plan the scrubbing pattern in advance. The longest track is around the perimeter of the area to be cleaned. For efficient operation, the runs should be the longest possible without turning, stopping, or raising and lowering scrub deck/squeegee.
NOTE: In order to achieve the best possible results, the area which is to be cleaned should be
swept before scrubbing. Large debris, strings & wire must be removed to prevent being caught in brushes or squeegee.
MACHINE OPERATION
TO BEGIN SCRUBBING
! |
When operating the machine around people, pay close attention for unexpected movement. Use extra caution around children.
! |
Flammable liquids and/or reactive metals can cause explosions or fire! Do not pick up.
1.Turn the machine power on.
2.Lower the squeegee.
3.Turn the vacuum on.
4.Lower the scrub brushes to the floor.
5.Turn the scrub brushes on (brushes will start when machine is propelled).
6.Drive machine forward to begin scrubbing. NOTE: Shut machine off immediately if water or foam is expelled from the machine.
7.Adjust the speed of the machine, solution flow and scrub brush pressure as necessary.
NOTE: Once solution flow rate is set it is not necessary to shut off solution when stopping scrubbing. Solution flow is automatically shut off when brush motors stop. When brush motors are activated, flow automatically resumes.
TO STOP SCRUBBING
1.Release the propel levers.
2.Turn the scrub brushes off.
3.Raise the scrub brushes.
4.Raise the squeegee.
5.Turn the vacuum off.
6.Turn the machine power off.
CUTTER 36V (SCEX) 86037040 12/12/06 |
|
