MACHINE TROUBLESHOOTING
PROBLEM | CAUSE | SOLUTION |
Little or no solution flow to the floor | Solution tank empty | Fill solution tank |
| Solution flow turned off or | Turn on or increase flow |
| set too low | setting |
| Solution strainer plugged | Clean solution strainer |
| Solution hoses obstructed | Clear obstruction from |
| hose | |
| Solution solenoid valve | Clean or replace |
| obstructed or stuck | |
| Vent hole in solution tank | Clear obstruction from vent |
| lid obstructed | hole |
No power to machine | Battery disconnected | Check all battery cable |
connections | ||
| Emergency | Reset |
| activated (If included) | |
| Battery connections | Clean connections |
| corroded | |
| Faulty main contactor | Replace contactor |
| Faulty key switch | Replace switch |
Little or no propel | Low battery charge | Charge batteries |
| Wheels spin | Decrease brush pressure |
|
| Allow cool down period |
|
| Adjust brush shroud if |
| Controller overheated | needed |
|
| Check motor wires and |
| Loose connection | connection |
CUTTER 36V (SCEX) 86037040 12/12/06 |
