![](/images/new-backgrounds/1125306/1253065x1.webp)
| Table of Contents | |
OPERATION |
|
|
Introduction | 4 | |
Wallplate Control Panel | 5 | |
Automatic Operation | 6 | |
Manual Operation | 8 | |
Stowing Dish | 8 | |
INSTALLATION |
|
|
Tools Needed | 3, 9 | |
System Components, Specifications, Warranty Information | 9 | |
Installation Requirements | 10 | |
Mounting Assembly on Roof | ||
Mounting Interior Wall plate Controller | 14 | |
Wiring | 15 | |
PARTS |
|
|
Antenna Parts | 16 | |
Base Assembly | 17 | |
Turret Assembly/Cover | 18 | |
ADDITIONAL INFORMATION |
|
|
Troubleshooting | ||
Parts included: | Tools needed for installation: |
|
18 “Reflector | Level |
|
Backup structure | Tape measure |
|
Mount base/turret | Phillips screwdriver |
|
Mount cover & bracket | Electrical tape |
|
Vent tube | Cutter |
|
Cable entry plate | Electric or cordless drill |
|
Hardware | 1/8” drill bit (for pilot holes) |
|
Cable | 7/16” wrench (for dish assembly) |
|
Interior wall plate controller | 5/16” socket/nut driver |
|
Surface mount box |
| |
| Sealant compatible with roof material (check |
|
| with your vehicle manufacturer for compatibility) |
FCC PART 15 STATEMENTS
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accor- dance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer- ence by one or more of the following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes or modifications to this equipment not expressly approved by Winegard Company may void
the user’s authority to operate this equipment.
3