![](/images/new-backgrounds/1125306/12530611x1.webp)
Automatic System Operation
After parking and leveling vehicle, look for trees, buildings, hills or mountains that might block the satellite signal.
ABOUT YOUR RECEIVER:
If you have a DISH NetworkTM receiver, be sure your system
Contact DIRECTV at
FIRST TIME USE:
System is factory preset to find 119°W (DISH Network). For other providers’ satellites, see page 7, Note 2. The first time your system is used, it could take up to 10 minutes for GPS acquisition. (This is also true if you have stored your system for six months or longer, or for vehicles without ignition systems [towables]). This is typical of first time use; do not think there is a malfunction.
1. | Turn TV on and tune to channel 3 or 4 (the output |
| of your receiver). |
2. | Turn on your satellite receiver. The receiver MUST BE |
| TURNED ON and LNBF COAX PROPERLY AT- |
| TACHED (refer to your receiver owner manual). |
3. | Press the POWER button on the wall plate controller |
Wall Plate Controller
| for one second. (Pressing CANCEL will stop the |
| search at any time during any process.) |
4. | The Winegard logo, then Software Rev. 1.XX appear |
| briefly on the display. |
5. | “Acquiring GPS” appears and remains until the |
| system acquires the GPS (Global Positioning |
| System) signal. |
6. | “Computing look angles” appears. The system is |
| comparing GPS data and the satellite selected. |
| Dish/Direct 119° W will be displayed; identify the |
| satellite related to your receiver. |
7. | For first time operation from your location (see |
| Note 2, p. 7): |
Power
Stow
Manual
Cancel
ANTENNA
POWER
Enter
• “Searching for satellite” is displayed. The system is |
searching for the satellite and is setting the elevation |
for the chosen satellite based on GPS information. |
During this process, the message will be replaced by |
“Determining satellite location.” |
• The system will begin finding the available satellites |
while the message “Determining satellite location.” is |
displayed. During this process, you may see a picture |
or signal from the desired satellite, but the system will |
move on to other satellites, “remembering” their |
location. Your signal disappears during this process. |
• After your system has locked on the satellite of your |
choice, the display will read “Enjoy the show.” |
8. If you want to change to a different satellite, |
wait for message displayed as “Pick a sat < >”. Use |
LEFT or RIGHT buttons to scroll through the list of |
available satellites for your receiver. After you find the |
desired satellite, press ENTER. |
•“Moving to (select satellite)” will be displayed while the system moves to that satellite. “Current Sat” with the selected satellite will appear on the display when locked on that satellite.
9.If you have NOT MOVED from your loca- tion, and want to watch the same satel- lite and dish is stowed:
•Press POWER. “Press ENTER to select last satellite” will be displayed after GPS is acquired. Press ENTER to move the system back to the last satellite viewed. You do not have to perform the
search function.
(See NOTES and other information on page 7.)
6