Winegard SS-3000 About Your SS-3000 Antenna Installation, Installation

2 3
Thank you for choosing the low profile SS-3000 antenna. Winegard antennas
are designed to deliver sharp, clear, high definition signal reception. At
Winegard, our engineering department is dedicated to designing antennas
that embrace both the latest technology and the aesthetics of any viewing
environment. The SS-3000 installs in minutes; it’s easy to use and simple to
adjust. Before installing your antenna, please remove all parts from the box,
and read the manual carefully.
Attaching the clips to the Reflector
1. Lay the reflector flat on the table.
2. Grip the reflector with your thumb and index finger, and bend the
reflector’s top and bottom edges towards you. (See Fig. 2, 3.)
3. With your other hand, grasp the clip, and attach it to the reflector at the
two notches.
4. Repeat steps 2 and 3 for all four clips.
Fig. 3
Fig. 2
Notch
Notch
ANT.
TV
Reflector
Antenna
(4) Clips
Antenna Base
AC Adaptor
(Supplied)
6’ Standard
Coax Cable
(Supplied)
Coax Cable to Digital
TV, Digital Converter
Box, Distribution Amp
or Splitter
LED
Power IN
6’ Mini Coax Downlead
Power
Injector
Collar Clamp
1. Find clamp collar half with two holes. Attach to antenna with the two long
screws. Do not tighten at this time.
An additional piece of RG6/U coax cable
can be used to extend the cable length
from the antenna to the Power Injector up
to 50’. Use FS-8100 cable to cable connec-
tor to combine cables.
FRONT OF ANTENNA
POINT TOWARD
SIGNAL
About Your SS-3000 Antenna Installation
Installation