Gas Cooktop Installation | 13 |
Install the Cooktop
Remove the cooktop, gas pressure regulator, burner grates and burner caps from the shipping package.
Lower the cooktop into the countertop
IMPORTANT NOTE: When repositioning the cooktop in the countertop opening, lift the entire cooktop up from the opening to prevent scratching the countertop.
Apply the foam strip, included in the hardware package, to the underside of the cooktop frame. Refer to the illus- tration below.
Reinsert the cooktop into the countertop opening. Align the rear edge of the cooktop frame with the pencil line and check that it is parallel to the front edge of the countertop. Lift the entire cooktop to make adjustments.
Attach the brackets to the bottom of the unit. Insert the
31/2" (89) clamping screws into the brackets. Use a screw- driver to tighten the clamping screws against the under- side of the countertop. Refer to the illustration below. Do not overtighten screws.
IMPORTANT NOTE: Do not seal the cooktop to the coun- tertop. It must be removed if service is necessary.
wolfappliance.com/specs
GAS PRESSURE REGULATOR
Install the gas pressure regulator with the arrow on the regulator pointing up toward the unit and in a position where you can reach the access cap. Refer to the illustra- tion below.
IMPORTANT NOTE: All connections must be
COOKTOP |
ARROW |
POINTS UP |
ACCESS |
CAP |
Gas pressure regulator.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
COOKTOP | FOAM | |||
BURNER BOX | STRIP | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Foam strip.
| COUNTERTOP |
COOKTOP |
|
BRACKET | CLAMPING |
| SCREW |
Bracket. |
|
